HP MPX200 Multifunction Router - Manual (Page 82)

Syntax
show vlan
Keywords
Specifies to use IPv4. -ipv4
1
Specifies to use IPv6. -ipv6
1
Specifies the iSCSI port number. -port=
1
Only one of these keywords can be used on the same command line.
Example
c:\> rcli show vlan -port=1 /ip=10.0.0.12
[10.0.0.12]
IPv4 VLAN ENABLED, VLAN ID = 32, VLAN Priority = 2
show vp_group
The show vp_group command displays detailed information for a single VP group.
NOTE: This command is not supported for MPX100 routers.
TIP: To view a list of all VP groups, use the list vp_group command.
Syntax
show vp_group
Keywords
Specifies the index number for the VP group for which you want to view information. -vpgIndex
If this keyword is not used, detailed information for all VP groups is displayed.
Example
c:\> rcli show vp_group -vpgIndex=1
[10.0.0.12]
Index: 1 "VPGROUP_1" is Enabled
show zone
The show zone command displays zone information for the fabric connected to one or more
Fibre Channel ports on the router.
Syntax
show zone
Keyword
Specifies the Fibre Channel port number for which you want to view zone information. -port=
If you do not specify a port, zone information is displayed for all Fibre Channel
ports.
82 Command reference