HP MPX200 Multifunction Router - Manual (Page 104)

Specifies the offset position after processing this command. -offset=
Specifies the number of data migration log entries after all positioning keywords
have been evaluated. -previous=
1
The initial default is 20. A value of -1 displays all entries before the current position
in the log after evaluating the -basepos, -offset, and -time keywords.
Specifies the offset position after processing this command. -offset=
This option allows searching for an entry with a timestamp older than the specified
time in the format "MM/DD/YYYY HH:MM:SS" starting after -basepos and
-offset
have been evaluated and going in the previous direction.
-time=
1 Using both the -next and -previous keywords results in some duplicate content. The -next log entries display,
followed by the -previous log entries.
Example
c:\> rcli view dm_log -basepos=end -previous=20 /ip=10.0.0.12
[10.0.0.12]
2 04/09/2010 18:00:01 "Migration Job Removed" -dm_jobid=0 "HP
HSV340-0:VPG1:001 to HP HSV340-0:VPG1:003"
Source LUN ID: 1, Size = 100GB, WWULN =
6005-08B4-000D-225C-0001-C000-0020-0000
Destination LUN ID: 3, Size = 100GB, WWULN =
6005-08B4-000D-225C-0001-C000-0041-0000
Migration owner: 1 I/O Size = 64 Priority = 0
1 04/09/2010 17:56:23 "Migration Job Configured Only -- not started"
-dm_jobid=0 "HP HSV340-0:VPG1:001 to HP HSV340-0:VPG1:003"
Source LUN ID: 1, Size = 100GB, WWULN =
6005-08B4-000D-225C-0001-C000-0020-0000
Destination LUN ID: 3, Size = 100GB, WWULN =
6005-08B4-000D-225C-0001-C000-0041-0000
Migration owner: 1 I/O Size = 64 Priority = 0
104 Data Migration commands