HP MPX200 Multifunction Router - Manual (Page 22)

Syntax
destroy host
Keywords
Specifies the symbolic name for the new host. -host_id
For an explanation of the general keywords that apply to all commands, see “General keywords”
(page 12)
Examples
c:\>rcli destroy host -host_id=myHost /ip=10.0.0.12[10.0.0.12]
Host successfully removed
disable beacon
The disable beacon command disables flashing the router LEDs.
Syntax
disable beacon
Example
c:\> rcli disable beacon /ip=10.0.0.12 [10.0.0.12]
Beacon successfully turned OFF
disable fc_port
The disable fc_port command disables the specified Fibre Channel port.
Syntax
disable fc_port -port=port number
Example
c:\> rcli disable fc_port -port=1 /ip=10.0.0.12
FC Port 1 successfully disabled
disable io_statistics
The disable io_statistics command stops collection of data for read/write block counts
and I/O counts for a single LUN or for all LUNs.
NOTE: This command is supported with router firmware version 3.1.0.0 or later.
Syntax
disable io_statistics
Keywords
Specifies the WWPN of the storage array for which you want to stop collecting
data. -array_wwpn=
Specifies the Fibre Channel target WWPN of the storage array for which you want
to stop collecting data. -array_with_fc_target=
22 Command reference