HP MPX200 Multifunction Router - Manual (Page 24)

disable iscsi_port
The disable iscsi_port command disables the specified iSCSI port.
Syntax
disable iscsi_port
Keyword
Specifies the port number of the iSCSI port to disable. -port
Example
c:\>rcli disable iscsi_port -port=1 /ip=10.0.0.12
iSCSI Port 1 successfully disabled
discover iscsi_target
The discover iscsi_target command discovers iSCSI targets at a specified IP address.
NOTE: This command is supported with router firmware Version 3.2.3.0 or later.
Syntax
discover iscsi_target
Keywords
Specifies that CHAP is enabled for this initiator. Values are: -chap_enable=
•
yes
• no
•
on
• off
•
true
•
false
If this keyword is not used, CHAP is disabled.
Specifies a CHAP password. -chap_secret=
This keyword is ignored if CHAP is not enabled.
Specifies the iSCSI target IPv4 or IPv6 address. -iscsi_ipaddr
Specifies the outbound iSCSI port number. -port
Specifies the TCP port to use on the iSCSI target. The value must be in the range of
1024 to 65534. -tcp_port=
If this keyword is not used, the default port is 3260.
Example
c:\> rcli discover iscsi_target -port=1 -iscsi_ipaddr=10.0.0.5
/ip=10.0.0.12
iSCSI Target discovery successful
enable beacon
The enable beacon command enables flashing the router LEDs.
24 Command reference