HP MPX200 Multifunction Router - Manual (Page 52)

FC1 advanced info successfully configured
set features
The set features command sets the license key to enable extended features on the router.
Syntax
set features -key=license key
Example
c:\> rcli set features -key=abcdef /ip=10.0.0.12
[10.0.0.12]
FCIP 1Gig Capable Licensed
FCIP SACK Capable No License Needed
DM Offline Capable No License Needed
DM Online Capable No License Needed
DM Capacity Capable 10240 GB Issued, 0 GB Used, 0 GB In-Use
DM Array Capable 9 Array Issued, 1 Used
set iscsi
The set iscsi command sets an iSCSI port configuration.
Syntax
set iscsi
Keywords
Specifies the port number for the iSCSI port that you want to configure. -port=
Specifies the static IPv4 address for the iSCSI port. -ipv4_addr=
Default is the current setting on the router.
Disables use of IPv4 for the iSCSI port. -ipv4_disable
If this keyword is used, all other IPv4-related keywords are ignored.
Default is the current setting on the router.
Specifies the IPv4 subnet mask. Default is the current setting on the router. -ipv4_subnet=
Specifies the IPv4 gateway address for the iSCSI port. -ipv4gw_addr=
Default is the current setting on the router.
Specifies the default router IPv6 address for the iSCSI port. -ipv6_def_addr=
Default is the current setting on the router.
Disables use of IPv6 for the iSCSI port. -ipv6_disable
If this keyword is used, all other IPv6-related keywords are ignored. Default is the
current setting on the router.
Specifies the static global IPv6 address for the iSCSI port. -ipv6_glob_addr=
Auto-config not supported for iSCSI ports.
Default is the current setting on the router.
Specifies the site-local IPv6 address for the iSCSI port. -ipv6_site_addr=
Auto-config not supported for iSCSI ports.
Default is the current setting on the router.
NOTE: Some older router hardware does not support IPv6.
52 Command reference