HP MPX200 Multifunction Router - Manual (Page 83)

Example
c:\> rcli -port=1 /ip=10.0.0.12
[10.0.0.12]
Zone set: CA_101 (FC1)
Zone: My_mpx200_vp1
Port Name 21:0:0:c0:dd:12:f9:5c
Port Name 21:0:0:c0:dd:12:f9:5d
Port Name 21:0:0:c0:dd:12:f9:66
Port Name 21:0:0:c0:dd:12:f9:67
Port Name 50:1:43:80:1:19:5e:4b
Port Name 50:1:43:80:1:19:5e:4e
Zone: My_mpx200_vp2
Port Name 21:1:0:c0:dd:12:f9:5c
Port Name 21:1:0:c0:dd:12:f9:5d
Port Name 21:1:0:c0:dd:12:f9:66
Port Name 21:1:0:c0:dd:12:f9:67
Port Name 50:1:43:80:1:19:5e:4b
Port Name 50:1:43:80:1:19:5e:4e
Zone set: CA_101 (FC2)
Link down -- cannot retrieve zone information
Zone set: CA_101 (FC3)
Link down -- cannot retrieve zone information
Zone set: CA_101 (FC4)
Link down -- cannot retrieve zone information
test notification
The test notification command tests an existing notification profile by sending a trial email
message to the recipients listed in the profile.
Syntax
test notification
Keywords
Specifies the name of a notification profile to be tested. -name
Example
c:\> rcli test notification -name="my Profile" /ip=10.0.0.12
[10.0.0.12]
Notification profile test started OK
tracert system
The tracert system command traces the route from the management port to a specified IP
address.
NOTE: This command does not support the use of iSCSI ports for outbound router tracing.
Syntax
tracert system -ping_ipaddr=IPv4 or IPv6 address
test notification 83