HP MPX200 Multifunction Router - Manual (Page 53)

Example
c:\> rcli set iscsi -port=1 -ipv4_static -ipv4_addr=10.0.0.5
/ip=10.0.0.12
iSCSI Port 1 basic info successfully configured
set iscsi_adv
The set iscsi_adv command sets an advanced iSCSI port configuration.
Syntax
set iscsi_adv
Keywords
Specifies the port number for the iSCSI port that you want to configure. -port=
Specifies a bandwidth limit for the iSCSI port. Values are: -bandwidth=
•
A positive number ≤125 for 1 Gb iSCSI port
• A positive number ≤1250 for 10 Gb iSCSI port
The default value is set on the router. Set to 0 to remove a previously applied limit.
This keyword is supported with router firmware Version 3.3.0.0 or later.
Enables CHAP for the iSCSI port. Values are: -chap_enable
•
yes
•
no
• on
•
off
• true
•
false
If CHAP is enabled, the -chap_secret keyword defaults to an empty string unless
it is included on the command line.
Specifies the CHAP secret for the iSCSI port. -chap_secret
Enables the data digest for the iSCSI port. Values are: -data_digest_enable
•
yes
•
no
• on
•
off
• true
•
false
The default value is set on the router.
Enables the header digest for the iSCSI port. Values are: -header_digest_enable
•
yes
•
no
• on
•
off
• true
•
false
The default value is set on the router.
set iscsi_adv 53