HP MPX200 Multifunction Router - Manual (Page 76)

NOTE: If none of the optional keywords are used, detailed information is displayed for all LUN
masks known to the router.
If a LUN, VP group, and target are all specified, LUN masks are displayed for all initiators for a
single LUN.
If only one or two keywords are used, detailed information is displayed for all LUN masks that
match the input. For example, if only -vpgindex is used, detailed information is displayed for
all LUN masks relating to any LUNs on any targets that are in that VP group.
To use this command with the -lun_serial, -lun_wwuln, -lun_eui, -lun_naa, or
-lun_any_wwuln
keyword requires router firmware version 3.2.3.0 or later.
Syntax
show lunmask
Keywords
Specifies the WWPN of the LUN mask for which you want to view detailed
information. -array_wwpn=
If this keyword is not used, the command displays detailed information for all LUN
masks.
Specifies the FC target WWPN of the LUN mask for which you want to view detailed
information. -array_with_fc_target=
Specifies the iSCSI target name of the LUN mask for which you want to view detailed
information. -array_with_is_target=
Specifies the WWULN, T10, NAA, EUI, or Page 0x80 serial number of the LUN
mask for which you want to view detailed information. -array_with_lun_any_wwuln=
Specifies the EUI of the LUN mask for which you want to view detailed information. -array_with_lun_eui=
1
Specifies the NAA of the LUN mask for which you want to view detailed information. -array_with_lun_naa=
1
Specifies the Page 0x80 serial number of the LUN mask for which you want to view
detailed information. -array_with_lun_serial=
1
Specifies the T10 designator of the LUN mask for which you want to view detailed
information. -array_with_lun_tten=
1
Specifies the WWULN of the LUN mask for which you want to view detailed
information. -array_with_lun_wwuln=
1
Specifies the symbolic name of the LUN mask for which you want to view detailed
information. -array_with_name=
Specifies the information to display. Options are: -display=
•
lun —Lists LUNs and the initiators masked for each.
•
initiator —Lists initiators and the LUNs for which they have masks.
•
target —Lists targets, masked LUNs, and the initiators masked for each LUN.
Specifies the Fibre Channel initiator name. -fc_initiator=
2
Specifies the Fibre Channel target name. -fc_target=
3
Required, unless the —fc_initiator or —is_initiator keyword is used
instead. Specifies the symbolic name for a host. —host_id
Specifies the iSCSI initiator name. -is_initiator=
2
Specifies the iSCSI target name. -is_target=
3
Accepts the LUN name in a variety of formats that are interpreted first as WWULN,
and then as the T10, NAA, EUI, and Page 0x80 serial number designator until at
least one LUN is found. -lun_any_wwuln=
76 Command reference