HP MPX200 Multifunction Router - Manual (Page 56)

set notification
The set notification command configures notifications, including IP addresses and port
numbers for SMTP servers, and contact information such as phone number, street address, and
email addresses.
NOTE: Specify one IPv4 or IPv6 address each for the primary and secondary SMTP servers.
Syntax
set notification
Keywords
Specifies the contact email address. -contact_email=
Default is as currently set on the router.
Enables or disables e-mail notifications. Values are: -email=
•
yes
•
no
• on
•
off
• true
•
false
The default value is as currently set on the router.
Enables or disables HTTP notification. Values are: -http=
•
yes
•
no
• on
•
off
• true
•
false
The default value is as currently set on the router.
NOTE: If HTTP notification is enabled, you must use the -url keyword to specify
the web address.
Specifies the sender email address for generated messages. -from=
Default is as currently set on the router.
Specifies the static IPv4 address for the iSCSI port. -ipv4_addr=
Default is the current setting on the router.
Disables use of IPv4 for the iSCSI port. -ipv4_disable
If this keyword is used, all other IPv4-related keywords are ignored.
Default is the current setting on the router.
Specifies the IPv4 subnet mask. -ipv4_subnet=
Default is the current setting on the router.
Disables use of IPv6 for the iSCSI port. -ipv6_disable
If this keyword is used, all other IPv6-related keywords are ignored.
Default is the current setting on the router.
Specifies the global IPv6 address for the iSCSI port. -ipv6_glob_addr=
Default is the current setting on the router.
56 Command reference