HP MPX200 Multifunction Router - Manual (Page 44)

Keyword
Indicates a file name to receive the report text. -file=
If no directory is specified, the file is saved in the current working directory.
If this keyword is not used, the report is displayed on the console.
Example
c:\> rcli report log -file=logreport.txt
Report saved successfully to file: "logreport.txt"
rescan system
The rescan system command scans LUNs for a specified target or storage array, or for all
targets known to the router.
NOTE: This command requires router firmware Version 3.2.3.0 or later.
Syntax
rescan system
Keyword
Specifies the storage array as a WWPN. -array_wwpn=
If this keyword is not used, LUNs are rescanned for all storage arrays known to the
router.
Specifies the Fibre Channel target WWPN of the storage array for which you want
to scan. -array_with_fc_target=
Specifies the iSCSI target name of the storage array for which you want to scan. -array_with_is_target=
Specifies the WWULN, T10, NAA, EUI, or Page 0x80 serial number of the storage
array LUN for which you want to scan. -array_with_lun_any_wwuln=
Specifies the EUI of the storage array LUN for which you want to scan. -array_with_lun_eui=
1
Specifies the NAA of the storage array LUN for which you want to scan. -array_with_lun_naa=
1
Specifies the Page 0x80 serial number of the storage array LUN for which you want
to scan. -array_with_lun_serial=
1
Specifies the T10 designator of the storage array LUN for which you want to scan. -array_with_lun_tten=
1
Specifies the WWULN of the storage array LUN for which you want to scan. -array_with_lun_wwuln=
1
Specifies the symbolic name of the storage array for which you want to scan. -array_with_name=
1
Do not combine the keywords -array_with_lun_serial, -array_with_lun_wwuln, -array_with_lun_tten,
-array_with_lun_eui , and -array_with_lun_naa. To specify any LUN, use the -array_with_lun_any_wwuln
keyword.
Example
c:\> rcli rescan system
[10.0.0.12]
rescan LUNs successful for Storage Array "0000-0100-0200-0000"
reset_factory system
The reset_factory system command restores the router factory-default configuration.
After issuing this command, you must reboot the router.
44 Command reference