HP MPX200 Multifunction Router - Manual (Page 36)

Specifies that the IPv6 link local address is used for the local end of this FCIP route. -uselinklocal
1
Enables use of a VLAN for the newly-created route. Values are: -vlan_enable=
•
yes (default)
•
no
•
on
•
off
•
true
•
false
The default is as currently set on the router.
1
You can specify either the -local_ip or -uselinklocal keyword, but not both.
Example
c:\> rcli modify fcip_route -fc_port=1 -vlan_enable=n /ip=10.0.0.12
FCIP route successfully modified
modify host
The modify host command changes the OS type for an existing host.
Syntax
modify host
Keywords
Specifies the symbolic name for the new host. -host_id
Indicates one of the following OSs: -ostype
Windows Server 2003 (default) win2k3
Windows Server 2008 win2k8
Windows Server 2012 win2k12
Linux 2.4.0 linux24
Linux 2.6.0 linux26
HP-UX (HP™UNIX™) (valid only for iSR6152)
hpux
IBM™ Advanced Interactive Executive (AIX™)
aix
Novell™ NetWare netware
Sun™ Solaris™SPARC™ solaris
Apple™Macintosh™
mac
VMware™
vmware
Open Virtual Memory System (OpenVMS) openvms
Other OS not listed here other
For an explanation of the general keywords that apply to all commands, see “General
keywords” (page 12)
Examples
c:\>rcli modify host -host_id=myHost -ostype=win2k8 /ip=10.0.0.12
[10.0.0.12]
Host successfully modified
36 Command reference