HP MPX200 Multifunction Router - Manual (Page 84)

Keywords
Specifies the number of times to ping at each hop. -count=
If this keyword is not used, the default ping count is 3.
Specifies the outbound port as mgmt for the management port. -port=
This keyword is optional, but if used, it must specify the outbound port as mgmt.
Example
c:\> rcli tracert system -port=mgmt -ping_ipaddr=10.0.0.11 /ip=10.0.0.12
1) 10.0.0.11 Min: <1 ms Max: 1 ms Avg(3): <1 ms
unmap global_iscsi_target
The unmap global_iscsi_target command removes the global iSCSI target from the specified
Fibre Channel port.
NOTE: This command is supported with router firmware Version 3.3.1.0 and later.
Syntax
unmap global_iscsi_target
Keywords
Specifies the Fibre Channel port number, where the first port is 1. -fc_port=
Example
c:\> rcli unmap global_iscsi_target -fc_port=1
iSCSI Global Target successfully unmapped from FC port 1
unmap target
The unmap target command removes the mapping from an iSCSI or Fibre Channel target to
an iSCSI or Fibre Channel port.
NOTE: You must specify either the -fc_target or -is_target keyword, but not both.
You must specify either the -fc_port or -ge_port keyword, but not both.
Syntax
unmap target
Keywords
Specifies the Fibre Channel port number, where the first port is 1. -fc_port=
Specifies the Fibre Channel target name. -fc_target=
Specifies the GbE port number, where the first port is 1. -ge_port=
Specifies the iSCSI target name. -is_target=
Specifies the virtual port group index starting at 1. The default is VP group 1. -vpgindex=
Example
c:\> rcli unmap target -fc_target=5001-4380-025C-C7D8 -ge_port=1
84 Command reference