HP MPX200 Multifunction Router - Manual (Page 18)

Specifies the world wide node name of a Fibre Channel initiator. -wwnn=
Specifies the world wide port name of a Fibre Channel initiator. -wwpn=
Example
c:\> rcli add initiator -wwpn=2101-00E0-8B3A-E348
-wwnn=2001-00E0-8B3A-E348 -ostype=win2k8 /ip=10.0.0.12 FC Initiator
successfully added, (WWPN: 2101-00E0-8B3A-E348)
add lunmask
The add lunmask command adds a LUN mask to the list known to the router. A LUN mask enables
a specified initiator to use a specified LUN.
NOTE: To use this command with the -lun_serial, -lun_wwuln, -lun_eui, -lun_naa,
or -lun_any_wwuln keyword requires router firmware version 3.2.3.0 or later.
Syntax
add lunmask
NOTE: You must specify either the -fc_initiator or -is_initiator keyword, but not
both.
You can specify either the -fc_target or -is_target keyword, but not both.
Keywords
Specifies the WWPN of the LUN mask that you want to add. -array_wwpn=
Specifies the Fibre Channel target WWPN of the LUN mask that you want to add. -array_with_fc_target=
Specifies the iSCSI target name of the LUN mask that you want to add. -array_with_is_target=
Specifies the WWULN, T10, NAA, EUI, or Page 0x80 serial number of the LUN
mask that you want to add. -array_with_lun_any_wwuln=
Specifies the EUI of the LUN mask that you want to add. -array_with_lun_eui=
1
Specifies the NAA of the LUN mask that you want to add. -array_with_lun_naa=
1
Specifies the Page 0x80 serial number of the LUN mask that you want to add. -array_with_lun_serial=
1
Specifies the T10 designator of the LUN mask that you want to add. -array_with_lun_tten=
1
Specifies the WWULN of the LUN mask that you want to add. -array_with_lun_wwuln=
1
Specifies the symbolic name of the LUN mask that you want to add. -array_with_name=
Specifies the name of the Fibre Channel initiator for which you want to add a LUN
mask. -fc_initiator=
Required, unless the -host_id or -is_initiator keyword is used instead.
Specifies the name of the Fibre Channel target for which you want to add a LUN
mask. -fc_target=
Required, unless the —fc_initiator or —is_initiator keyword is used instead. -host_id=
Specifies the symbolic name for a host for which you want to add LUN mask.
Specifies the name of the iSCSI initiator for which you want to add a LUN mask. -is_initiator=
Required, unless the -host_id or -fc_initiator keyword is used instead.
Specifies the name of the iSCSI target for which you want to add a LUN mask. -is_target=
Accepts the LUN name in a variety of formats that are interpreted first as WWULN,
and then as the T10, NAA, EUI, and Page 0x80 serial number designator until at
least one LUN is found. -lun_any_wwuln=
2
18 Command reference