HP MPX200 Multifunction Router - Manual (Page 55)

The default is the current setting on the router.
Specifies the IPv4 or IPv6 port address. -isns_ipaddr
The default is the current setting on the router.
Specifies the iSNS port number. -isns_port
The default is the current setting on the router.
Example
c:\> rcli set isns -enable=y -isns_ipaddr=10.0.0.10 -isns_port=1026
/ip=10.0.0.12
iSNS successfully configured
set mgmt
The set mgmt command sets the management port IP addresses.
Syntax
set mgmt
Keywords
Specifies the IPv4 address for the management port. -ipv4_addr=
Enables DHCP for the IPv4 address for the management port. -ipv4_dhcp
1
Disables use of IPv4 for the management port IP addresses. -ipv4_disable
If this keyword is used, all other IPv4-related keywords are ignored.
Specifies the static IPv4 address for the management port. -ipv4_static
1
Default is the current setting on the router.
Specifies the IPv4 subnet mask for the management port. -ipv4_subnet=
If this keyword is not used, the default subnet mask is 255.255.255.0.
Specifies the IPv4 gateway address. -ipv4gw_addr=
Enables auto-config for the management port IPv6 address. Default is the current
setting on the router. -ipv6_auto
2
Specifies the default router IPv6 address for the management port. -ipv6_def_addr=
Disables use of IPv6 for the management port address. -ipv6_disable
If used, all other IPv6-related keywords are ignored.
Specifies the global IPv6 address for the management port. -ipv6_glob_addr=
Specifies the site-local IPv6 address for the management port. -ipv6_site_addr=
Specifies the static IPv6 address for the management port. Default is the current
setting on the router. -ipv6_static
2
1 You can use either the -ipv4_static or -ipv4_dhcp keyword, but not both.
2 You can use either the -ipv6_static or -ipv6_auto keyword, but not both.
Example
c:\> rcli set mgmt -ipv4_static -ipv4_addr=10.0.0.12
-ipv4_subnet=255.255.254.0 -ipv4gw_addr=10.0.0.1 /ip=10.0.0.12
Management Port successfully configured
set mgmt 55