HP VMA-series Memory Arrays User Manual
Page 93
AM456-9007B Rev 02
HP VMA SAN Gateway Installation and User Guide
93
The
show
commands described in this section can be used in Config or Enable
mode. All other media management commands require Config mode. (See
The following six command and option combinations are described below:
•
show media
•
show media all
•
show media global
•
show media block id all
•
show media block id
•
show media block detail
show media
The
show media
command returns all media devices that can be used as block
storage on the current HP VMA SAN Gateway (node or module). This command
shows a summary line for each device location, giving the size and status of that
device.
The
show media
command is an alias for
show media block id all
command. Media used by the system for purposes other than block storage are not
shown.
health
Display status information and lifetime remaining for
media devices. For more information on the
health
option, see
id
Display information for a specified media device or all
media (
id all
).
Table 5.1 Show Media Options
Location Media ID Model Size Status
------------------------------------------------------------------------
unknown-00 Fender1002 VMA Array 6895.75G online
unknown-01 Strad130 VMA Array 432.00G online