HP VMA-series Memory Arrays - Manual (Page 118)

118 AM456-9007B Rev 02 HP VMA SAN Gateway Installation and User Guide
Enable Mode
The enable command moves the CLI to Enable mode. This mode has commands
to view all state information and take certain kinds of actions, such as rebooting the
system or configuring some system parameters, but it excludes commands that
configure the cluster. Its commands are a superset of those in Standard mode. The
disable command moves the CLI from Enable mode back to Standard mode.
The exit command (in Enable mode) closes the CLI.
User accounts with the monitor role can use all Enable mode commands.
Config Mode
The configure terminal command moves the CLI from Enable mode to
Config mode.
• On the cluster’s master node, Config mode has a full unrestricted set of
commands to view anything, take any action, or change any configuration. Its
commands are a superset of those in Enable mode.
• On nodes other than the master, Config mode only includes commands that
operate on the local node. Using a global command on a standby or normal
node either has a temporary local effect (which is overridden as soon as the
node synchronizes with the master node) or produces an error message which
identifies the master node where the command can be used.
The exit command moves the CLI from Config mode to Enable mode. Using the
exit command twice closes the CLI, or you can use the quit command to close
the CLI directly.
To return to Standard mode from Config mode, first exit Config mode and then
disable the Enable mode.
User accounts with the admin role can use all Config mode commands.
Prompt and Response Conventions
The prompt format is:
[: ]
The prompt begins with the hostname of the node and, in brackets, the cluster name
and role of the node in that cluster (master, standby, normal, or unknown). The end