HP VMA-series Memory Arrays - Manual (Page 194)

194 AM456-9007B Rev 02 HP VMA SAN Gateway Installation and User Guide
Network Page
The Network page shows the basic network configuration information for the HP
VMA SAN Gateway cluster.
The IP address for cluster management is set as part of the initial out-of-the box
configuration using a serial cable connected in console mode.
Software The Software section displays the software
version number and allows you to choose which
boot image the HP VMA SAN Gateway should
use (the Switch Boot Partition button). Two
boot images are installed for each HP VMA
SAN Gateway in separate partitions.
Configuration The Configuration section allows you to save
your current configuration setting to a specified
file (the Save button). You can also apply a
previously saved configuration file to the HP
VMA SAN Gateway cluster (the Apply button)
if it is available locally on the HP VMA SAN
Gateway or remotely on another server.
The Status column indicates which
configuration file is active. The active file is
backed up as .bak .
The DELETE button removes any selected
(checked) configuration files from the system.
Figure B.13 Network Settings Page