HP VMA-series Memory Arrays - Manual (Page 163)

AM456-9007B Rev 02 HP VMA SAN Gateway Installation and User Guide 163
Enable (or disable) the listen interface restricted list for snmpd. If enabled and at
least one non-DHCP interface is specified in the list, the snmp connections are only
accepted on those specified interfaces. When disabled, snmp connections are
accepted on any interface.
[no] snmp-server listen interface
Provides a mechanism to add and remove interfaces to the "listen" list. If the
interface is also running as a DHCP client, it will be as if the interface was not
added. If DHCP is later turned off on this interface, it will be as if the interface was
then added to the listen list.
snmp-server community
no snmp-server community
Set the community name required to be supplied with SNMP requests to the
system.
snmp-server contact
no snmp-server contact
snmp-server location
no snmp-server location
Set the syscontact and syslocation variable served from the System MIB in MIB-II.
snmp-server host traps [version <1,2c>] string>
no snmp-server host
Add or remove a host to which SNMP traps should be sent. Note that this setting
is only meaningful if traps are enabled, though the list of hosts may still be edited
if traps are disabled.
[no] snmp-server host disable
Disable a trap sink without actually removing it altogether from the configuration.
All trap sinks are created enabled.
[no] snmp-server traps event
Specify which types of events should be sent as SNMP traps. By default the entire
list of notifiable events are sent as SNMP traps to any declared trap sinks. This
command enables or disables a single event for conversion to an SNMP trap.
show snmp