HP VMA-series Memory Arrays - Manual (Page 74)

74 AM456-9007B Rev 02 HP VMA SAN Gateway Installation and User Guide
Syntax Description
Configuring Initiator Groups
The third step in configuring the vSHARE system is to configure the initiator
groups (igroups) which identify the initiators (hosts) that are allowed to access a
LUN or set of LUNs.
Every initiator has a protocol-specific identifier used to access storage.
Fibre Channel initiators are identified by World-Wide Names (WWN). Fibre
Channel initiators are fixed by the appropriate HBA port.
Initiator Group Configuration Overview
1. From the CLI, enter into Enable mode using the enable command and then
Config mode using the configure terminal command.
Run the igroup name command to create an initiator group and one or more
initiators within that group. The initiator_name must be a valid wwn (Fibre
Channel) name..
The command creates the initiator within the initiator group.
[node ] Displays targets on node ID.
[hostname ] Displays targets on hostname.
[protocol fc] Displays targets using protocols FC.
[id ] Displays a specific target.
[sessions] Displays targets including sessions.
[detail] Displays in detail.
Table 4.1 show targets Command
> enable
# configure terminal
(config) #
(config) # igroup create name initiators
wwn.21:00:00:1b:32:9a:18:65