HP VMA-series Memory Arrays - Manual (Page 173)

AM456-9007B Rev 02 HP VMA SAN Gateway Installation and User Guide 173
The show targets command displays all Fibre Channel. Use the hostname ,
protocol , and id parameters to filter the targets returned.
The command returns the node, hostname, target port, status (enabled or not), and
address (WWN). The detail parameter returns the network bindings for each
target.
Quick Reference to Commands
This section lists the commands that are documented in this guide; it does not
include every command that is available in the CLI.
S: Standard Mode
E: Enable Mode
C: Config Mode no Variant Command See section starting on page #
C [no] aaa page 153
C [no] arp page 152
C [no] banner page 159
E, C [no] boot page 143
S, E, C [no] cli page 159
C [no] clock page 129
C [no] cluster heartbeat enable page 147
C [no] cluster master address vip page 147
C [no] cluster name page 147
E, C cluster shutdown page 147
C cluster upgrade page 122
C configuration page 140
E [no] configure page 144
E, C debug page 135
E disable page 144
E, C [no] email page 131
S enable page 144
S, E, C exit page 144
E, C file debug-dump page 146
E, C file stats page 140
Table A.1 CLI Commands Documented in This Guide