beautypg.com

Network bond commands – HP VMA-series Memory Arrays User Manual

Page 150

background image

150

AM456-9007B Rev 02

HP VMA SAN Gateway Installation and User Guide

[no] interface zeroconf

The command may be used to enable or disable use of zero configuration

networking (

zeroconf

) on the specified interface. This randomly chooses a

unique Link Local IPv4 address from the 169.254/16 block. zeroconf is an

alternative to DHCP.

show interfaces [] configured
show interfaces [] brief

Display information about the specified interface, or all interfaces if one is not

named.

Either

configured

or

brief

or neither may be specified. With neither, detailed

information about the runtime state of the interface is given. With

brief

,

abbreviated runtime state, with the interface statistics excluded, is shown. With

configured

, the configuration of the interface is shown rather than its runtime

state.

Network Bond Commands

The

network bond

command enables you to define two or more network

interfaces (data ports) as a single logical address called eth0 and to define the mode

by which these interfaces are aggregated together.

network bond eth0 mode [balance-abalance-rr|backup|balance-
xor|balance-xor-layer3+4|broadcast|link-agg|link-agg-
layer2+3|link-agg-layer3+4|balance-tib|balance-alb]
interface interface

The command aggregates two interfaces together as a bonded group called eth0.

The interfaces share the same subnet.

Ten network bonding modes are supported:

balance-rr

Round robin balancing

backup

Backup fault-tolerant mode

balance-xor

XOR load balancing

balance-xor-
layer3+4

XOR load balancing Layer 3 + 4 mode

broadcast

Broadcast fault-tolerant mode

This manual is related to the following products: