HP VMA-series Memory Arrays - Manual (Page 245)

AM456-9007B Rev 02 HP VMA SAN Gateway Installation and User Guide 245
vimm-state-change State Change State One or more VIMMs have
changed state on a VMA
Array. A comma separated
list of VIMMs are provided
for each state: admin_down,
booting, active, spare,
failed, present, or alarmed.
The set value for each
VIMM list / state change is
“true” for set or “false” for
clear. Check the VMA Array for
alarms to determine severity
of state change. High / Low
vimm-temperature-high 80 Celsius VIMM temperature has
exceeded normal operating
range Check airflow and operating
environment. High
vimm-temperature-ok 75 Celsius VIMM temperature has
dropped into normal
operating range Nothing. Low
array-fan-change State Change State One or more fans have
changed state on a VMA
Array. The old and new
values are provided using
the following states: OFF,
Absent, Low, Medium, or
High. Check VMA Array for
alarms as well as airflow
and operating environment. Medium
disk-io-high 5120 KBytes /
sec The internal disk on a HP
HP VMA SAN Gateway has
crossed a threshold for
performing too many I/O’s
per second. If the system is not under
data traffic load, please
contact HP customer
support. Low
fc-port-state-change State Change State One or more Fibre Channel
ports have changed state on
an HP VMA SAN Gateway.
The old and new values for
state are provided from one
of: Unknown, Failover
Failed, Failover, Not
Supported, Online, Lost,
Dead, Unconfigured. The
FC port speed is included in
the data but not used to
generate the state change.
The following speed values
are used: 1 Gbit, 2 Gbit, 4
Gbit, and 8 Gbit. Verify that OM-3 rate Fibres
are used in your config for 8
Gb. Check that the Fibres
and SFP ports were properly
cleaned and that the cables
and SFP’s are fully inserted.
Verify that the Fibre does
not exceed bend radius
specifications. Medium
license-state-change State Change State an HP VMA SAN Gateway
feature license state has
changed. The old and new
active state is passed as well
as the specific feature
license. The active state is a
“true” or “false” value.
When true, the feature
license is active. If a license has changed to
active = false, please contact
HP customer support to see
if your license has expired. Medium