HP VMA-series Memory Arrays - Manual (Page 129)

AM456-9007B Rev 02 HP VMA SAN Gateway Installation and User Guide 129
recovered after it is set. These two commands are thus named for Cisco
compatibility.
The nopassword command means that no password is required to log in. The
disable command configures the account so that no one can log into that account.
The disable password command leaves the account as a whole the same, but
forbids login with a password. It is assumed that ssh key access will be used
instead. To re-enable the account, the user must un-disable it, and put a password
on it.
The no username disable command prints a message to this
effect; it only exists to avoid stumping users with an apparently irreversible
command.
Disabling a user account does not terminate any current sessions that user has open;
it just prevents new sessions from being established.
show users
Display the username of the currently logged-in user, and the capabilities that user
has.
show usernames
Display a list of all user accounts and the capabilities of each.
NTP, Clock, and Time Zones
clock set []
Set the system clock. The time must be specified. The date is optional; if not
specified, the date will be left the same.
clock timezone
no clock timezone
Set the system time zone. The time zone may be specified in one of three ways:
• A nearby city whose time zone rules to follow.
The system has a large list of cities that can be displayed by the help and
completion system. The city names are organized hierarchically. A given city