HP VMA-series Memory Arrays - Manual (Page 240)

240 AM456-9007B Rev 02 HP VMA SAN Gateway Installation and User Guide
SNMP Configuration on the HP VMA SAN Gateway
Use the snmp and snmp-server commands to configure SNMP. It defaults to
on.
Traps
Twenty two traps are enabled by default, as shown below.
*lab-ib-srv1 [lab-ib-srv1: master] (config) # show snmp
SNMP enabled: yes
SNMP port: 161
System location:
System contact:
Read-only community: public
Traps enabled: yes
Trap community: public
Interface listen enabled: yes
No Listen Interfaces.
Trap sinks:
10.1.1.1
Enabled: yes
Type: traps version 2c
Community: public (default)
10.1.1.2
Enabled: yes
Type: traps version 2c
Community: public (default)█