HP VMA-series Memory Arrays - Manual (Page 164)

164 AM456-9007B Rev 02 HP VMA SAN Gateway Installation and User Guide
Display all SNMP configuration options.
VMA Web Interface Configuration
[no] web enable
Enable or disable the VMA Web Interface.
[no] web http enable
Enable or disable HTTP access to the VMA Web Interface. This setting is only
meaningful if the VMA Web Interface as a whole is enabled.
web http port
no web http port
Set the port number for HTTP. The default is 80. The no command resets it to the
default, but does not disable HTTP.
[no] web https enable
Enable or disable HTTPS (HTTP over SSL) access to the VMA Web Interface his
setting is only meaningful if the VMA Web Interface as a whole is enabled.
web https port
no web https port
Set the port number for HTTPS. The default is 443. The no command resets it to
the default, but does not disable HTTPS.
[no] web httpd listen enable
Enable (or disable) the listen interface restricted list for HTTPD. If enabled and at
least one non-DHCP interface is specified in the list, the http connections are only
accepted on those specified interfaces. When disabled, http connections are
accepted on any interface.
[no] web httpd listen interface
Provides a mechanism to add and remove interfaces to the "listen" list. If the
interface is also running as a DHCP client, it will be as if the interface was not
added. If DHCP is later turned off on this interface, it will be as if the interface was
then added to the listen list.