HP VMA-series Memory Arrays - Manual (Page 137)

AM456-9007B Rev 02 HP VMA SAN Gateway Installation and User Guide 137
If both prompts are enabled, and the configuration was unsaved, the user will be
prompted twice.
The noconfirm parameter suppresses both of these confirmations if it is specified.
reload force
If the system is busy performing another operation requiring the management
subsystem (which is almost any management operation), the regular reload
[halt] command will block until it is finished. If rebooting the system is urgent,
the reload force command will do it immediately.
This reboots the system, and there is no halt variant. There is also never any
confirmation, whether or not there are any unsaved changes to the configuration.
debug generate dump
Generate a debugging dump. The dump can then be manipulated using the file
debug-dump ... family of commands.
Statistics
stats clear-all
stats sample clear
stats chd clear
stats alarm clear
Clear all memory of the specified sample, computed historical data-point (CHD),
or alarm, or of all of those together. Clearing a sample or CHD deletes all of the
gathered data. Clearing an alarm resets it to a non-error state, clears the
watermarks, and forgets the event history.
stats sample interval seconds>
Change the amount of time between samples for the specified group of sample
data.
Stats Alarm
[no] stats alarm enable