HP VMA-series Memory Arrays - Manual (Page 135)

AM456-9007B Rev 02 HP VMA SAN Gateway Installation and User Guide 135
Add or remove an email address from the list of addresses to send email
notifications of events.
[no] email notify recipient class info
[no] email notify recipient class failure
Enable or disable the sending of informational or failure events to the specified
recipient. Each event type is classified as either informational or failure .
The specified recipient will receive the intersection of the set of events specified
by this command, and the set of events specified overall with the [no] email
notify event command.
[no] email notify recipient detail
Specify whether the emails this recipient is sent should be detailed or summarized.
Each email potentially has both a detailed and summarized form, where the
detailed form has a superset of the information. (In practice, only PM process
failure emails currently have a detailed form; for everything else, the two are the
same.)
[no] email autosupport enable
Enable or disable the sending of email to vendor autosupport when certain failures
occur.
email autosupport mailhub
no email autosupport mailhub
Set the mail relay to use to send autosupport emails.
email send-test
Send a test email to all of the configured notification email recipients. This is useful
to make sure the configuration works without having to wait for an event to occur.
show email
Display notification settings. This does not include SNMP traps, which are under
the snmp-server command tree.
Diagnostic Tools
ping []
traceroute []