HP VMA-series Memory Arrays - Manual (Page 149)

AM456-9007B Rev 02 HP VMA SAN Gateway Installation and User Guide 149
links. See Dual Gateways with 1–2 3000-Series Arrays, Highly Available on page
233 for more information.
interface ip address
no interface ip address
Set or clear the IP address and netmask of this interface.
interface mtu
no interface mtu
Set the maximum transition unit (MTU) of this interface. The no variant resets the
MTU to its default.
interface duplex [auto|full|auto]
no interface duplex
Set the interface duplex. Note that setting it to auto also sets speed to auto .
Setting it to one of the manual settings half or full also sets the speed to a
manual setting which is determined by querying the interface to find out its current
auto-detected state.
interface speed [10|100|1000|10000|auto]
no interface speed
Set the interface speed. Note that setting it to auto also sets duplex to auto .
Setting it to one of the manual settings (generally 10 , 100 , or 1000 ) also sets the
duplex to a manual setting which is determined by querying the interface to find
out its current auto-detected state.
[no] interface dhcp
Enable or disable use of DHCP on the specified interface. The command gets the
IP address and netmask via DHCP so those settings are ignored. Setting the IP
address and netmask disables DHCP implicitly, though it can also be disabled
explicitly using the no form of this command. It is TBD which of the other
configuration items (DNS servers, default gateway) are overridden by DHCP.
interface dhcp renew
Force a restart on the DHCP client for the specified interface.
[no] interface shutdown
Enable or disable the specified interface.