Event notification – HP VMA-series Memory Arrays User Manual
Page 131
AM456-9007B Rev 02
HP VMA SAN Gateway Installation and User Guide
131
Disable or re-enable an NTP server or peer. Servers and peers start enabled;
disabling is just a way of making them temporarily inactive without losing their
configuration.
[no] ntp enable
[no] ntp disable
Enable or disable NTP overall. Note that the latter is the Cisco command; the
former is just a pair of aliases added to increase usability, as otherwise it may be
hard for a user to figure out how to enable NTP if they are not aware of
no
commands and only see a way to disable it.
show ntp
Display current NTP settings.
Event Notification
[no] email enable
Enable or disable the sending of e-mail when certain events occur. These events are
the same as those for which SNMP traps can be sent (see
email mailhub
no email mailhub
Set or clear the mail relay to use to send notification emails.
email mailhub-port
no email mailhub-port
Set the mail relay port to use to send notification emails. The
no
variant resets the
port to its default, which is 25.
email domain
no email domain
Set the domain name to be used as the source for e-mail notifications. The specified
domain name is used in conjunction with the system hostname to form the source
e-mail address.
The rules are as follows: