HP VMA-series Memory Arrays - Manual (Page 160)

160 AM456-9007B Rev 02 HP VMA SAN Gateway Installation and User Guide
• terminal .. . commands are clones of a subset of the cli session .. .
commands, and are only present for Cisco compatibility. All of these
commands are INTERACTIVE (not available from the Scheduler).
Note that some settings, such as the terminal length and width, are inherently
session-specific, and there are no corresponding commands to set the defaults in
configuration.
cli default auto-logout
cli session auto-logout
no cli default auto-logout
no cli session auto-logout
Control the length of user inactivity required before the CLI will automatically log
a user out. The no ... variants of this command disable the automatic logout
feature.
[no] cli default paging enable
[no] cli session paging enable
Enable or disable paging of CLI output. If paging is enabled, all command output,
as well as all help text printed when the ? key is pressed, will be displayed one
screen at a time, using the same pager as the 'show log' command uses. If the text
to be displayed fits on a single screen, it will be printed normally and the pager will
not be used.
Note that the abbreviated list of commands printed when is hit twice is not
paged, even in the unlikely event that it does not fit on the screen.
Note that if the CLI does not have a terminal (for example, it is being driven by a
script), paging is disabled automatically regardless of the default setting, and
cannot be re-enabled for this session. However, even in this case, the default setting
can still be changed.
[no] cli default show config-hidden enable
Enable or disable showing hidden commands in the output of the various forms of
show config ... . By default, hidden commands are displayed to better ensure
the output of show config ... represents the running state of a system.
[no] cli default confirm lose-unsaved
Enable or disable confirmations of cases where you might accidentally lose
unsaved changes. Currently, this is just for the reload [halt] command; other
cases where you might lose configuration are just some of the configuration