Show configuration – HP VMA-series Memory Arrays User Manual
Page 61
AM456-9007B Rev 02
HP VMA SAN Gateway Installation and User Guide
61
Show Configuration
The
show configuration
commands enable you to view the commands
required to bring a fresh system up to match a given configuration.
•
show configuration
•
show configuration running
•
show configuration files
•
show configuration full
•
show configuration running full
•
show configuration unsaved
The output of each of these commands begins with a short header that contains the
name and version number of the configuration in a comment.
With the exception of the
show configuration full
and
show
configuration running full
commands, output omits commands that are
not required because they set parameters to their default values.
show configuration
The
show configuration
command displays commands to reproduce the state
saved in the active configuration file.
show configuration running
The
show configuration running
command displays commands to
reproduce the state of the current running configuration, which could include some
unsaved configuration settings.
The show running-config and the write
terminal commands are the same as
show configuration running
command.
show configuration files
The
show configuration files
command displays
commands to reproduce the state saved in the specified configuration file.
show configuration full
The
show configuration full
command displays all commands, including
any default settings, to reproduce the state saved in the active configuration file.
show configuration running full