HP VMA-series Memory Arrays - Manual (Page 104)

104 AM456-9007B Rev 02 HP VMA SAN Gateway Installation and User Guide
LUN Set Commands
[no] lun set container name readonly
The lun set command enables you to set a LUN as read-only. The lun set
command is the only command usable after a LUN has been created except the no
lun create … readonly command.
Managing Targets
Show Targets Command
show targets [node ] [hostname ]
[protocol fc] [id ] [sessions] [detail]
The show targets command displays all Fibre Channel targets. Use the
hostname , protocol , and id parameters to filter the targets returned.
The command returns the node, hostname, target port, status (enabled or not), and
address (WWN). The detail parameter returns the network bindings for each
target.
Managing Block Storage in the VMA Web Interface
The vSHARE management pages in the VMA Web Interface provide you with
tools for managing LUNs, initiator groups, and targets in four pages: the LUN
Status page, the LUN Management page, the Initiator Management page, and the
Target Management page.
Monitoring LUN Status
A container is an addressable partition within a VMA Array. Every LUN created
and managed by vSHARE is created within a storage container.