HP VMA-series Memory Arrays - Manual (Page 166)

166 AM456-9007B Rev 02 HP VMA SAN Gateway Installation and User Guide
Remove all state associated with the specified . If the job has not
executed, the timer event is canceled. If the job was executed, the results are
deleted along with all other job state.
job date-time []
job date-time []
Set the time for the job to execute. If the time specified is in the past, the job will
not execute and will be in the "inactive" state. If the job is currently scheduled and
the indicated time is in the past, the job will be canceled.
An hour and minute must be specified; optionally, seconds and/or a date may be
specified. The date must be in either yyyy/mm/dd or yyyy-mm-dd format. The
date if not specified defaults to the epoch ( 1/1/7 0).
no job date-time
Clears the scheduled date-time for the job.
job enable
Set the job state to enable . If the specified time is in the future, schedule the job
for execution and place the job in the "pending" state.
no job enable
Cancel any potential execution of the job. Place the job in an inactive state.
job execute
Force an immediate execution of the job. The timer (if set) is not canceled and the
job state is not changed. The job will not be run if not currently enabled.
job name
no job name
Specify a name for the job. The no command deletes the name.
job fail-continue
no job fail-continue
When job failure-continue is specified, a job will execute all the
commands in the job regardless of any single command failure or error. Otherwise,
the first command to fail will cause the job to cease executing commands.
show jobs