HP VMA-series Memory Arrays - Manual (Page 41)

AM456-9007B Rev 02 HP VMA SAN Gateway Installation and User Guide 41
Logging into the HP VMA SAN Gateway
Once you have connected to the KVM console or serial port, you are prompted to
log in. Enter the username admin (bold shows user input):
The admin user does not have a default password.
Once logged in, you are prompted whether to use the configuration wizard, as
shown below:
The configuration wizard will prompt you to enter the configuration information
and parameters discussed in the following subsections.
Configuring the Master HP VMA SAN Gateway
The first step in Phase 2 of an HP VMA SAN Gateway deployment is to configure
the master node of the HP VMA SAN Gateway cluster and define the global cluster
parameters, which are inherited by each node subsequently added to cluster.
A typical HP VMA SAN Gateway vCLUSTER consists of one or more HP VMA
SAN Gateways (nodes), one of which is designated as the master node and another
which is designated as the standby node. Additional nodes beyond the master and
standby in a vCLUSTER are called normal nodes.
tc500-1973fa login: admin
Unauthorized Access Prohibited. Usage of the HP VMA SAN Gateway is subject
to the HP License agreement which is included under this product's
Web Interface Help section.
HP VMA SAN Gateway
HP VMA SAN Gateway configuration wizard
Press '?' for help, Ctrl+B to go back to the previous step.
Default value is in square brackets: press Enter to accept it.
Press Ctrl+R to clear default to enter empty string.
Press Ctrl+C to jump to the end of the wizard at any time.
Do you want to use the wizard for initial configuration?