HP VMA-series Memory Arrays - Manual (Page 155)

AM456-9007B Rev 02 HP VMA SAN Gateway Installation and User Guide 155
radius-server host {hostname , ip-address} [auth-port number>] [timeout ] [retransmit ] [key
]
no radius-server host {hostname , ip-address} [auth-port
]
Add a RADIUS server to the set of servers used for authentication. Some of the
parameters given may override the configured global defaults for all RADIUS
servers. The auth-port defaults to 1812 and is used for authentication requests.
The same IP address can be used in more than one radius-server host
command as long as the auth-port is different for each. auth-port is a UDP
port number. auth-port must be specified immediately after the host option (if
present).
If no radius-server host {hostname , ip-address} is specified, all
radius specific configuration for this host is deleted. no radius-server host
{hostname , ip-address} auth-port may be specified to refine
which host is deleted, as the previous command will delete all RADIUS servers
with the specified ip-address.
RADIUS servers are tried in the order they are configured.
show radius
Show the RADIUS configuration.
Note: We do not have CLI commands to specify the acct-port (accounting port)
or retransmit on a per server basis. Also, there is no radius-server deadtime
command as there is in the Cisco command set.
TACACS+ Configuration
tacacs-server timeout
no tacacs-server timeout
Sets (or resets to the default) a global communication value for all TACACS+
servers. Can be overridden in a tacacs-server host command. Defaults to 5.
Sets the wait time for retransmitting a request to any TACACS+ server. Range is
1-60.
tacacs-server retransmit
no tacacs-server retransmit