HP VMA-series Memory Arrays User Manual
Page 101
AM456-9007B Rev 02
HP VMA SAN Gateway Installation and User Guide
101
Media Read and Write Statistics
The
show stats media
commands enable you to view read and write rates (in
MB per second) for both the current ten-second sample and an average of the
samples taken over the last five minutes.
The
show stats media
command displays read and write statistics for block
storage media devices in one or more nodes in the cluster. The scope of each
command is the same as the corresponding
show media
command, described
above.
show stats media
The structure of the
show stats media
commands is identical to the
show
media
commands described above, except that these commands also support a
continuous
option to display a continually updating view of the statistics.
If the
continuous
option is specified, the display of statistics is updated
continually. Use CTRL+ C to exit the display.
The command
show stats media
is an alias for
show stats media block
id all
. The command returns information about storage media devices on the
local HP VMA SAN Gateway and omits all non-block storage media.
SM075 [NJ-Lab-vSHARE00: master] # show stats media
Media Stats Summary (sampled @10 secs)
Read (bytes/s) Write (bytes/s)
Location Media ID Current Last 5m Current Last 5m
------------------------------------------------------------------------
unknown-00 Fender1002 36.81M 34.90M 35.91M 37.21M
unknown-01 Strad130 46.27M 46.00M 32.72M 33.62M