HP VMA-series Memory Arrays - Manual (Page 143)

AM456-9007B Rev 02 HP VMA SAN Gateway Installation and User Guide 143
Run the initial-configuration wizard. The wizard is automatically invoked
whenever the CLI is launched when the active configuration file is fresh (that is,
not modified from its initial contents). This command invokes the wizard on
demand.
show configuration [full]
Display a list of CLI commands that will bring the state of the a fresh system up to
match the current persistent state of this system. A short header is included,
containing the name and version number of the configuration, in a comment.
Commands which are not required because they would set something to its default
are not included—thus running this command on a fresh configuration will
produce no output, aside from the header.
Note that this does not include changes that have been made but not yet written to
persistent storage.
The full option will also include commands that set things to their defaults, but
excludes those of them that are instances of hidden commands.
show configuration running
Same as show configuration except that it applies to the currently running
configuration, rather than the current persisted configuration. The command show
running-config is for Cisco compatibility.
show configuration files [filename]
If no filename is specified, display a list of configuration files in persistent storage.
If a filename is specified, display the commands to recreate the configuration in
that file. In the latter case, only non-default commands are shown, as for the normal
show configuration command; the full , all , and subtree options are not
available.
Image Management
boot system location
boot system next
Specify which location the system should boot from by default. If next is used,
set the boot location to be the next one after the one currently booted from. (This
does not mean the next one after the one we are currently set to boot from; thus the