Dwyer UXF3 User Manual
Ultrasonic flowmeter
Table of contents
Document Outline
- Introduction
- SAFETY PRECAUTIONS
- CAUTION ON INSTALLATION LOCATION
- Contents
- PRODUCT OUTLINE
- INSTALLATION AND BEFORE START OF OPERATION OF THE FLOW TRANSMITTER
- INSTALLATION
- Parameter
- Description of display/setting unit
- Composition of key operation
- Parameter initial value list
- Parameter protection
- Display language
- Checking and Setting of Piping Specifications/Detector
- Zero Adjustment
- Setting of unit
- Output Setting
- Application operation of parameter
- MAINTENANCE MODE
- How to calibrate the analog output
- How to set the constant current output
- How to check the action of total pulses
- How to check the status output
- How to check the DI input
- How to validate the test mode (simulated flow rate output)
- How to validate a serial transmission (RS-232C/RS-485)
- How to set the ID No.
- How to confirm the software version
- Initializing setting parameters
- How to set the detailed setting
- Mounting of detector
- Detector mounting procedure
- Selection of mounting position
- Selection of mounting method
- Processing of mounting surface
- How to determine the mounting position
- Selection of acoustic couplant
- Cable end treatment
- Mounting small-diameter and medium size sensor (SX1-A, SX2-A)
- Mounting large size detector (SX1-C)
- Mounting small diameter detector (SX2-A)
- Mounting high temperature detector (SX2-B)
- CHECK AND MAINTENANCE
- Appendix