Dwyer UXF3 - Manual (Page 3)

-i-
Introduction
This instruction manual concerns the installation, operation, and maintenance of the flow transmitter, detectors,
and signal cables of the ultrasonic flow meter system. This manual should be read carefully prior to installation
and operation.
z Read the manual to gain an adequate understanding of proper operation of the equipment prior to
installation and operation. Improper results or hazardous conditions may result of improper installation,
operation or maintenance.
z The specifications of this flow meter are subject to change without prior notice for improvement of the
product.
z Do not attempt to modify the flow meter. Manufacturer shall not bear any responsibility for hazardous
conditions or improper operation as a result of unauthorized modification. If it becomes necessary to
modify the flow meter, contact the manufacturer in advance for consulation and permission.
z This instruction manual should always be kept on hand by the party responsible for operation.
z After reading the manual, store it in an accessible location for reference.
z This instruction manual should be delivered to the end user upon purchase or installation.
z If the instruction manual has been lost, request an appropriate replacement.
Dwyer Instruments, Inc. ©
Note
z Reproduction of this manual in whole or part is strictly prohibited
without prior written permission.
z Contents of the manual are subject to change without prior notice.
Issued in August, 2008
Bulletin F-107-UXF3
Modbus is a registered trademark of Schneider Automation.