Connection of sensor cable, Caution – Dwyer UXF3 User Manual
Page 99
-91-
5.9. Mounting small-diameter and medium size sensor
(SX1-A, SX1-B)
5.9.1. Connection of sensor cable
When engaging or disengaging the cover, be sure to wear protective gloves. Otherwise, you may cut a hand.
(1) Loosen the retaining knobs on the detector using a
screwdriver, then remove the cover from the detector.
Fig. 5-16
(2) Mount the sensors so that the upstream and
downstream sensors can be distinguished with each
other. Remove the cable clamp.
Note) In case of removing the cable clamp, be
sure not to lose the nut.
Fig. 5-17
CAUTION
Driver
Knob
Cover
Knob
Driver
Cable
clamp
Cable
clamp
Nut
Bulletin F-107-UXF3
See also other documents in the category Dwyer Accessories for air:
- 166T (1 page)
- 160S (2 pages)
- PAFS-1000 (1 page)
- 160F (2 pages)
- Mark II WSI (4 pages)
- MW-1 (2 pages)
- 89088 (12 pages)
- 660 (2 pages)
- 670 (16 pages)
- FLST (4 pages)
- AFG (6 pages)
- FAFM (2 pages)
- DAFM (2 pages)
- STRA (4 pages)
- 530 (2 pages)
- AVFS (2 pages)
- 641RM (4 pages)
- 641B (4 pages)
- 641 (4 pages)
- VTT (2 pages)
- SFI-700 (2 pages)
- GFM (32 pages)
- GFC (40 pages)
- DMF (44 pages)
- GFM2 (20 pages)
- GFM3 (22 pages)
- TFP-LI (30 pages)
- TFP-GI (27 pages)
- TBS (7 pages)
- HFT (4 pages)
- CAM (6 pages)
- PWD (3 pages)
- BAT (3 pages)
- FPCA (4 pages)
- FPCA (2 pages)
- SPK (4 pages)
- MFS (8 pages)
- LOFM (3 pages)
- FLMG (12 pages)
- MFS2 (16 pages)
- PFT (4 pages)
- IPFS (7 pages)
- UFB (48 pages)
- UFC (56 pages)
- Series PUB (44 pages)