How to set the flow rate unit, Bulletin f-107-uxf3 – Dwyer UXF3 User Manual
Page 42
-34-
4.8.2. How to set the flow rate unit
Description
z Select the unit of flow rate.
z Metric system
Flow rate ········· L/s, L/min, L/h, L/d, kL/d, ML/d, m
3
/s, m
3
/min, m
3
/h (factory set), m
3
/d, km
3
/d, Mm
3
/d, BBL/s, BBL/min, BBL/h, BBL/d,
kBBL/d, MBBL/d, gal/s, gal/min, gal/h, gal/d, kgal/d, Mgal/d, ft /s, ft /min, ft /d, kft /d, Mft /d, barrels (BBL units)
For actual keying, refer to the typical operation indicated below. Set the parameter protection to OFF beforehand. (See Section 4.4.1.)
Operation
(example)
Set a flow rate unit to “L/min”.
Key operation
Description
Display
ź
Press the
key 3 times to display “MEASURE SETUP”.
MEASURE SETUP
ENT
ź
Press the
ENT
key once to display “SYSTEM UNIT”.
SYSTEM UNIT
METRIC
ź
Press the
key once to display “FLOW UNIT”.
FLOW UNIT
m3/h
ENT
ź
Press the
ENT
key once to blink the cursor.
FLOW UNIT
m3/h
ź
Press the
key several times to display “L/min”.
FLOW UNIT
L/min
Press the
ENT
key once to register.
FLOW UNIT
COMPLETE
Ļ
ENT
ź
ź
ź
ź
ʊʊʊ “L/min” has been registered. ʊʊʊ
FLOW UNIT
L/min
ESC
Press the
ESC
key once and the
key twice to return to the
measurement mode.
0.000 m/s
0.000 L/min
Bulletin F-107-UXF3
3
3
3
3
3