Dwyer UXF3 - Manual (Page 70)

-62-
4.10.5.5. How to validate the range over output and pulse range over output
Description
z AO RANGE OVER
: Select a contact output as DO1, DO2 and/or DO3 when the upper limit and lower limit output are above the
setting.
z PULSE RANGE OVER : Select a contact output as DO1, DO2 and/or DO3 when the total pulse output exceeds the maximum output
frequency value.
For actual keying, refer to the typical operation indicated below. Set the parameter protection to OFF beforehand. (See Section 4.4.1.)
Operation
(example) Set the DO1 output to “AO RANGE OVER”.
Also, set the contact to “ACTIVE ON”.
Key operation Description Display
ź
Press the key twice to display “OUTPUT SETTING”.
OUTPUT SETTING
ENT
ź
Press the ENT key once to display “ZERO ADJUSTMENT”.
ZERO ADJUSTMENT
SET ZERO
ź
Press the key 6 times to display “DO1 OUT”.
* Press the key again to display “DO2 OUT”.
* Press the key once again to display “DO3 OUT”.
DO1 OUT
NOT USED
ENT
ź
Press the ENT key once to blink the cursor.
DO1 OUT
NOT USED
ź
Press the key 7 times to display “AO RANGE OVER” on the 2nd
line.
* Press the key again to display “PULSE RANGE OVER”.
DO1 OUT
AO RANGE OVER
Press the ENT key once to register “RANGE OVER”.
DO1 OUT
COMPLETE
Ļ
ENT
ź
ź
ź
ź
ʊʊʊ “RANGE OVER” has been registered. ʊʊʊ STATUS OUT
CONTACT ACTION
ENT
ź
Press the ENT key once to display “CONTACT ACTION”.
CONTACT ACTION
ACTIVE ON
Press the ENT key once to register “ACTIVE ON”(normally off).
* To select normally on , press the key.
CONTACT ACTION
COMPLETE
Ļ
ENT
ź
ź
ź
ź
ʊʊʊ “ACTIVE ON” has been registered. ʊʊʊ STATUS OUT
CONTACT ACTION
ESC Press the ESC key twice and then press the key 3 times to enter
the measurement mode.
0.000 %
0.000 m3/h
Bulletin F-107-UXF3