Dwyer UXF3 - Manual (Page 86)

-78-
4.11.8. How to set the ID No.
Description
z Set the ID No. for protection of parameters (Section 4.4.1).
If ID No. is set, the number must be inputted before canceling the parameter protection.
z To validate the parameter protection, set the parameter protection to "ON". (See Section 4.4.1.)
ID No. settable range: 0000 to 9999 (4-digit number)
For actual keying, refer to the typical operation indicated below. Set the parameter protection to OFF beforehand. (See Section 4.4.1.)
Operation
(example) Set “1106” as the ID No.
Key operation Description Display
ź
Press the key 4 times to display “MAINTENANCE MODE”.
MAINTENANCE MODE
ENT
ź
Press the ENT key once to display “RAS INFORMATION”.
RAS INFORMATION
0000000000000000
ź
Press the key 9 times to display “REGISTER ID NO.”.
REGISTER ID NO.
ENT
ź
Press the ENT key twice to blink on the 2nd line.
REGISTER ID NO.
0 000
ź
Set “1106” by the and the key.
REGISTER ID NO.
110 6
Press the ENT key once to register.
REGISTER ID NO.
COMPLETE
Ļ
ENT
ź
ź
ź
ź
ʊʊʊ ID NO. has been registered. ʊʊʊ REGISTER ID NO.
ESC Display the measurement mode by the ESC key and the key.
Note) To validate the parameter protection, set the parameter protection
to "PROTECT ON". (See Section 4.4.1.)
0.000 %
0.000 m3/h
4.11.9. How to confirm the software version
Description
z Indicates the software version.
For actual keying, refer to the typical operation indicated below.
Operation
(example) Check the software version.
Key operation Description Display
ź
Press the key 4 times to display “MAINTENANCE MODE”.
MAINTENANCE MODE
Press the ENT key once to display “RAS INFORMATION”.
RAS INFORMATION
0000000000000000
ENT
ź
*
ź
Press the key 10 times to display “VER. NO.”.
VER. NO.
UXF3-A1 01
ESC After checking, display the measurement mode by the ESC key or the
key.
0.000 %
0.000 m3/h
* The indicated version number is display example.
Bulletin F-107-UXF3