Dwyer UXF3 - Manual (Page 90)

-82-
5. Mounting of detector
5.1. Detector mounting procedure
Mount the sensor on the pipe, and perform the following steps in order before making measurement.
Reference
section Work item : Outline steps
5.2 Selection of mounting position : A place that provides enough space for the length of the straight
pipe.
5.3 Selection of mounting method : Check the V/Z method, pipe size, and detector.
5.4 Preparation of mounting surface : Perform preprocessing of the detector mounting pipe surface.
5.5 How to determine the mounting position : In mounting by the Z method, prepare the paper gauge, and wrap it
around the pipe, and put a mark on the sensor mounting position.
5.6 Selection of acoustic couplant : Select silicone compound or silicone-free grease for each application.
5.7 Cable end treatment : When cutting the cable, perform the end treatment.
5.8.1 Frame mounting method : Fastens the frame on pipe by the stainless belt.
5.8.2 Detector mounting method : Apply acoustic couplant to the detector oscillation surface, and
mount it on the frame to connect the sensor cable.
SX1-A
.
SX1-B SX1-C
.
SX2-A SX2-B
5.9.1 ̆ 5.10 (5.11) (5.12) Connection of sensor cable:
Connect the sensor cable to the sensor.
5.9.2 5.9.2 ̆ ̆ ̆ Assembly procedure of the sensor:
Assemble the detector which is connected to the
sensor cable.
5.9.3.1 5.9.3.2 5.10.2 5.11 5.12 Mounting method on the pipe:
Apply acoustic couplant to the detector oscillation
surface, and connect the sensor cable.
Bulletin F-107-UXF3