Dwyer UXF3 - Manual (Page 100)

-92-
(3) Insert the coaxial cable through the cable lead-in port
and loosen the terminal screws (G, +).
Note) Connect to the M4 crimp terminal side (Flow
transmitter side: M3)
Fig. 5-18
(4) Connect the cable to the terminal (black to G terminal,
red to + terminal).
Fig. 5-19
(5) Secure the coaxial cable with the cable clamp.
Fig. 5-20
(6) Remove any debris from the terminals, and mold
the silicone onto the terminals, sealing them.
z Cut off the tip of the silicone filler tube.
Apply silicone to the terminal block while pressing
the head of the tube against the bottom of terminals.
At this time, care should be taken to prevent entry of
air bubbles.
Fig. 5-21
(7) Put the cover on the detector.
Fig. 5-22
Screw
Coaxial cable
Cable clamp
Silicone filler
Bulletin F-107-UXF3