Dwyer UXF3 - Manual (Page 20)

- 12-
3.3. Installation of flow transmitter
The flow transmitter may be mounted on a wall or 2B pipe stand (option).
3.3.1. Wall mounting (Flow transmitter : UXF3)
For wall mounting, use two M8 bolts.
Drill holes according to the mounting hole dimensions shown below, and fasten the flow transmitter using the M8 bolts.
3.3.2. 2B pipe stand mounting (Flow transmitter : UXF3)
When mounting on 2B pipe, be sure to use a complete set of fixtures (U bolt, support fixture, plain washer,
spring washer, nut) furnished if optionally designated. Tighten the nut by hand. If any support fixture is not used
or if the assembly is excessively tightened by tool, the wall mounting fixture may be damaged.
Mount the instrument on 2B pipe stand as illustrated below.
Nominal Standard tightening torque
M8 12.5 [N˜m]
2B pipe stand
U bolt (M8)
Plain washer
Spring washer
Nut
Support fixture
Bulletin F-107-UXF3
[unit: mm]