Dwyer UXF3 - Manual (Page 65)

-57-
4.10.5. Setting the DO output
4.10.5.1. How to validate outputting the FULL SCALE 2
Description
z Select a contact output as DO1, DO2 and/or DO3 at FULL SCALE2 measurement status.
For actual keying, refer to the typical operation indicated below. Set the parameter protection to OFF beforehand. (See Section 4.4.1.)
Operation
(example) Set the DO1 output to “FULL SCALE2”.
Also, set the contact to “ACTIVE ON”.
Key operation Description Display
ź
Press the key twice to display “OUTPUT SETTING”.
OUTPUT SETTING
ENT
ź
Press the ENT key once to display “ZERO ADJUSTMENT”.
ZERO ADJUSTMENT
SET ZERO
ź
Press the key 6 times to display “DO1 OUT”.
* Press the key again to display “DO2 OUT”.
* Press the key once again to display “DO3 OUT”.
DO1 OUT
NOT USED
ENT
ź
Press the ENT key once to blink the cursor.
DO1 OUT
NOT USED
ź
Press the key 3 times to display “FULL SCALE2” on the 2nd line.
DO1 OUT
FULL SCALE2
Press the ENT key once to register “FULL SCALE2”.
DO1 OUT
COMPLETE
Ļ
ENT
ź
ź
ź
ź
ʊʊʊ “FULL SCALE2” has been registered. ʊʊʊ STATUS OUT
CONTACT ACTION
ENT
ź
Press the ENT key once to display “CONTACT ACTION”.
CONTACT ACTION
ACTIVE ON
Press the ENT key once to register “ACTIVE ON”(normally off).
* To select normally on, press the key.
CONTACT ACTION
COMPLETE
Ļ
ENT
ź
ź
ź
ź
ʊʊʊ ACTIVE ON has been registered. ʊʊʊ STATUS OUT
CONTACT ACTION
ESC Press the ESC key twice and then press the key 3 times to enter
the measurement mode.
0.000 %
0.000 m3/h
Bulletin F-107-UXF3