How to replace the fuse, Flow transmitter : uxf3 – Dwyer UXF3 User Manual
Page 113
-105-
6.3. How to replace the fuse
z
Be sure to turn off the power before replacing the fuse.
Fuse specifications
(1) AC power supply (100V and 200V): 5.2mm (diameter) × 20mm (long), 250V, 0.5A.
As represented by F. T. I. Co., Ltd. FGMB: 250V, 0.5A.
(2) DC power supply: 5.2mm (diameter) × 20mm (long), 250V, 1A.
As represented by F. T. I. Co., Ltd. FGMB: 250V, 1A.
6.3.1. Flow transmitter : UXF3
(1) Opening the cover after turning off power.
Loosen 4 screws from the flow transmitter front, and open the cover.
(2) Replace the fuse.
Detach the fuse holder from the power supply board, and replace the fuse. Then, return the fuse holder in place.
(3) Closing the cover.
Close the cover, and tighten 4 screws.
z
Turn on power only after closing the cover.
Bulletin F-107-UXF3
- 166T (1 page)
- 160S (2 pages)
- PAFS-1000 (1 page)
- 160F (2 pages)
- Mark II WSI (4 pages)
- MW-1 (2 pages)
- 89088 (12 pages)
- 660 (2 pages)
- 670 (16 pages)
- FLST (4 pages)
- AFG (6 pages)
- FAFM (2 pages)
- DAFM (2 pages)
- STRA (4 pages)
- 530 (2 pages)
- AVFS (2 pages)
- 641RM (4 pages)
- 641B (4 pages)
- 641 (4 pages)
- VTT (2 pages)
- SFI-700 (2 pages)
- GFM (32 pages)
- GFC (40 pages)
- DMF (44 pages)
- GFM2 (20 pages)
- GFM3 (22 pages)
- TFP-LI (30 pages)
- TFP-GI (27 pages)
- TBS (7 pages)
- HFT (4 pages)
- CAM (6 pages)
- PWD (3 pages)
- BAT (3 pages)
- FPCA (4 pages)
- FPCA (2 pages)
- SPK (4 pages)
- MFS (8 pages)
- LOFM (3 pages)
- FLMG (12 pages)
- MFS2 (16 pages)
- PFT (4 pages)
- IPFS (7 pages)
- UFB (48 pages)
- UFC (56 pages)
- Series PUB (44 pages)