Configure gpib – GW Instek GDS-2000A series User Manual User Manual

Page 229

REMOTE CONTROL CONFIG

229

Configure GPIB

Note

To use GPIB, the optional module, DS2-GPIB, must be
installed. Please see page 30 for installation details.

Connection

1. Connect a GPIB cable from a PC to the installed

GPIB module.

Configure GPIB

2. Press the Utility key.

Utility

3. Press I/O from the bottom menu.

4. Use the Variable knob to set the

GPIB Address from the side menu.
This option will only be available
when the GPIB module is installed.

Range

1 ~ 30

GPIB Constraints



Maximum 15 devices altogether, 20m cable
length, 2m between each device



Unique address assigned to each device



At least 2/3 of the devices turned On



No loop or parallel connection