GW Instek GDS-2000A series User Manual - Manual (Page 225)

REMOTE CONTROL CONFIG
225
7. Press Save Now to save the settings.
8. Connect the RS-232C cable
to the rear panel port: DB-9
male connector. For a
functionality check, see page
230.
Pin Assignment
1 2 3 4 5
6 7 8 9
2: RxD (Receive data)
3: TxD (Transmit data)
5: GND
4, 6 ~ 9: No connection
PC Connection Use a Null Modem connection as shown in the
diagram below.
GDS-2000A PC
RxD Pin2 RxD Pin2
GND Pin5 GND Pin5
TxD Pin3 TxD Pin3
Configure the Ethernet Interface
Ethernet
Configuration MAC Address Domain Name
Instrument Name DNS IP Address
User Password Gateway IP Address
Instrument IP
Address Subnet Mask
HTTP Port 80 (fixed)
Note
The Ethernet option, DS2-LAN, must first be installed
before proceeding. Please see page 30 for further
details.